Technical F1.P-SS

Return to Previous Page

  GENERAL 
Durable corrosion resistant construction specifically for outdoor use.

Heat input 12kW (41,000 BTU/h).

Gas type: Liquid Petroleum Gas LPG.

Flame protection by 100% shut off thermo electric valve.

Ignition of pilot by piezo igniter.

Bottle cover houses up to 13kg LPG cylinder.

The unit incorporates a hollow base which must be filled with ballast before use (not supplied).

Standard overall height: 2260 mm

Width at widest point: 860 mm

  LOCATION & COVERAGE 
A single heater will provide warmth with a diameter of up to 6 metres, depending on weather conditions.  Maintaining a comfort level in a sheltered area is easier than in an exposed area.  If possible locate heaters in places sheltered from winds, near buildings, walls, fences etc.

Groups of heaters can be used to heat large areas, positioning them to give overlapping heat patterns.  This gives an all round radiant warmth for even greater comfort.

LOCATION HEATER SPACING
Well shielded areas, mild climate Up to 6m
Shielded 2 sides, average climate 4.25m
Little shielding, cool climate 3m
Exposed, cold climate 2.5m
 

 

  ACCESSORIES & OPTIONS. 

Circular Table Top. Fits around pole above bottle cover.

Telescopic Pole. Lowers down into bottle cover for hire operators.

Clamp Down Lugs. Used to screw heater down to the floor for security in exposed locations.

Burner Cover Bag. For winter protection.

Tip Over Protection. Cuts off gas supply to burner if heater is tipped over.

Sack Trolley. To assist in transportation.

Factory Pre-assembly. Pre-assembly option (excludes ballast).

Special Design Option. The perforated Fiesta logo on the cylinder cover can be replaced with name/logos for bulk orders (subject to artwork).

Alternative Heights. Extra high & lower height heaters can be supplied to special order.

Extended Guarantee. Available

  IMPORTANT - SAFETY 

Combustible Materials. Heaters must be located such that the indicated safety clearance distances from combustible materials are ensured.

Storage and handling of gas bottles must be carried out in accordance with local codes of practice.  After connecting the gas supply to a heater, always check for gas leaks using a soap solution.

Refer to the manufacturer's Assembly and Use Instructions for further information.

Designed for outdoor use only, with adequate high and low level ventilation.

  SAFETY CLEARANCE DISTANCES 

 

Return to Previous Page


  Fiesta Outdoor Heaters
A division of:
Clifton Engineering (Worcester) Ltd.
Hilltop Works
Clifton upon Teme
Worcester WR6 6DZ

Tel:
Fax:
Email:

01886 812332 / 812224
01886 812706
info@fiestaheaters.com
 

Home

 

Design by PinkDylan 2003